In order for the EtherCAT bus to comply with all real-time time limits, the Linux operating system of the master must also provide a certain real-time performance. The RT performance of the master is measured with the maximum jitter time in microseconds.
The requirements vary depending on the system. Basically the maximum jitter should be less than 100us. Depending on the system, a larger jitter can be tolerated or a smaller jitter is necessary.
In networks with distributed clocks (DC) which are operated in MasterShift mode, all clocks are synchronized with a clock from a slave.
The master only has to send the EtherCAT packet early enough.
The exact timing is not relevant.
Fundamentally the following applies:
Calculation time of the control algorithm + Calculation time of the EtherCAT master + Maximum jitter < Period length
If the network is operated in BusShift mode or without DC, the RT requirements are higher.
In such systems the OS provides the clock for the whole system.
max. jitter OS = min jitter EtherCAT bus
If the master cannot guarantee a stable clock, the masterShift mode is recommended.
See Distributed Clocks for more information.
The Cyclictest is a software that can be used to easily measure the maximum jitter of a system. Cyclictest explains how to install and use the software.
sudo ./cyclictest -p 80 -t5 -n
If the RT performance is not sufficient, the maximum jitter could be reduced with the following measures:
Modern processors change the CPU frequency depending on the load to save power. With an RT-OS this can lead to increased jitter. If the frequency is fixed, the RT performance can be improved. ATTENTION: If the CPU is fixed at a high temperature, the CPU can run hot. If the Governor is changed manually, the CPU temperature should be monitored!
The frequency is controlled by the OS by a scaling governor.
The performance governor should run the cpu at the maximum frequency.
To get the current active governor:
cpupower frequency-info
To set the governor:
sudo cpupower frequency-set -g powersave
Intel cstates indicate the power saving state of the processor. These states can be locked with kernel parameters on the C0 state (no power saving measures).
Display current kernel parameters:
cat /proc/cmdline
Add the following kernel parameters: